<sst xmlns="http://schemas.openxmlformats.org/spreadsheetml/2006/main" count="91" uniqueCount="71"><si><t>telescope length</t></si><si><t>mm</t></si><si><t>cm</t></si><si><t>inches</t></si><si><t>Calculation units (select)</t></si><si><t>telescope main tube diameter</t></si><si><t>telescope max diameter</t></si><si><t>Preferred Units</t></si><si><t>Telescope Dimensions</t></si><si><t>Timber Dimensions</t></si><si><t>timber thickness</t></si><si><t>Calculated Part Sizes</t></si><si><t>side walls</t></si><si><t>length</t></si><si><t>width</t></si><si><t>end walls</t></si><si><t>No. required</t></si><si><t>dividers</t></si><si><t>lid and base</t></si><si><t>timber type (select)</t></si><si><t>plywood</t></si><si><t>MDF</t></si><si><t>softwood</t></si><si><t>Padding Dimensions</t></si><si><t>padding thickness</t></si><si><t>padding type</t></si><si><t>carpet</t></si><si><t>neoprene</t></si><si><t>foam</t></si><si><t>felt</t></si><si><t>Materials</t></si><si><t>Paddings</t></si><si><t>Units</t></si><si><t>end padding</t></si><si><t>divider cut-out padding strips</t></si><si><t xml:space="preserve"> </t></si><si><t>x2 Off</t></si><si><t>x4 Off</t></si><si><t>Sky at Night Magazine</t></si><si><t>Telescope Case Cutting List</t></si><si><t>Length</t></si><si><t>Width</t></si><si><t>Thickness</t></si><si><t>Material</t></si><si><t>required?</t></si><si><t>q</t></si><si><t>Number</t></si><si><t>Part</t></si><si><t>Telescope Case Dimensions</t></si><si><t>a</t></si><si><t>b</t></si><si><t>c</t></si><si><t>d</t></si><si><t>e</t></si><si><t>f</t></si><si><t>add more options to these lists to suit your project</t></si><si><t>enter the dimensions of your telescope, chosen units and choice of materials in the yellow cells below</t></si><si><t>A</t></si><si><t>B</t></si><si><t>C</t></si><si><t>D</t></si><si><t>Print off this cutting list once you have checked all the details on the "Calculations" worksheet. Take it to your timber yard or use it to mark out and cut your own parts</t></si><si><t>Print off this drawing and use it to mark out the cut-outs in each divider.</t></si><si><t>Telescope Case Divider Layout</t></si><si><t>diameter</t></si><si><t>saw cut</t></si><si><t>cut out</t></si><si><t>(optional) finder/focusser height above max diameter</t></si><si><t>E</t></si><si><t>(optional) dovetail height below max diameter</t></si><si><t>Note - this drawing is not to scale!</t></si></sst>
